Dave-smith-instruments TETRA User Manual download pdf (Page 53)

MIDI Implementation

Tetra receives MIDI data according to the mode controls under GLOBAL. In

addition, there is interaction between some of the program parameters that

determine the overall response of Tetra to MIDI data. Note that the following

applies to using both the MIDI jacks and USB.

Following are the Global parameters that affect response to MIDI:

MIDI Channel: ALL, 1…16 — Selects the MIDI channel to send and receive

data, 1 to 16. All receives on any channel.

Clock: see table — Selects the MIDI clock status as follows:

Display MIDI Clock Setting

Internal

MIDI clock is neither sent nor received

MIDI Out

MIDI clock is sent

MIDI In

MIDI clock is received

MIDIn/Out

MIDI clock is received and transmitted

MIDI Parameter Send: NRPN, CC, Off — Changes to the values of Tetra’s front

panel controls are transmitted via MIDI as Non-registered Parameter Number

(NRPN) controllers or as Continuous Controllers (CC). Transmission of

parameters can also be turned off.

MIDI Parameter Receive: All, NRPN, CC, Off — Sets the method by which

Tetra receives parameter changes via MIDI. As with transmission, NRPNs are

the preferred method, though some controllers may only be able to send CCs.

MIDI Control: Off, On — When On, the synth will respond to MIDI controllers,

including Pitch Wheel, Mod Wheel, Pedal, Breath, Volume, and Expression.

MIDI SysEx: Off, On — When On, the synth will respond to received MIDI

SysEx messages, and will transmit them, when prompted, to the MIDI Out.

MIDI Messages

System Real-time Messages

Status Description

1111 1000 MIDI Timing Clock

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 75 76

No comments

Dave-smith-instruments TETRA User Manual Page 53