Dave Smith Instruments Evolver User Manual download pdf (Page 23)

Note – if all three Delay taps are in use, the Levels of each should be set to lower

amounts to prevent overload distortion.

Time 1: 0…150, sync Sets the delay time of the first delay tap. 0 - 150 will

adjust the delay from zero to 1 second at 16 bits 48KHz sampling, no compression.

The middle range steps are in tuned semitones (noticeable with Feedback 1 turned up

high). Since delay is a time measurement, higher delay numbers are lower

frequencies. Step 22 corresponds to C7 (2,093 Hz), down to step 94 which is tuned to

C1 (32.7 Hz).

After 150 the sync delay times as shown in the table below. The delay time can be set

in multiples of a single sequencer step, or exact divisions of a step.

Note - depending on the current sequence speed, the longer sync delays may not

be reachable. For example, at Tempo of 60 BPM and Clock Divide of Quartr

(quarter note) each beat takes one second, so if you set it to 2 Steps (Delay is 2

steps in length), the delay should be two seconds. But, there is only enough

memory for one second of delay, so it will not work. When too slow as in this case,

simply clamping it at one second would not likely be a multiple of the step time.

So, if the requested time is too long, the requested time is cut in half until it fits

within the one second of available memory. So, don’t be surprised if changing

longer sync delay times does not make any difference to the sound.

Display Timing Sync

32 Steps

Delay is 32 steps in length

16 Steps

Delay is 16 steps in length

8 Steps

Delay is 8 steps in length

4 Steps

Delay is 4 steps in length

2 Steps

Delay is 2 steps in length

1 Step

Delay is 1 step in length

1/2 Step

Delay is one-half step in length

1/4 Step

Delay is one-quarter step in length

1/8 Step

Delay is one-eighth step in length

1/16Step

Delay is one-sixteenth step in

length

6 Steps

Delay is 6 steps in length

3 Steps

Delay is 3 steps in length

1.5 Step

Delay is one and a half steps in

length

2/3 Step

Delay is two-thirds of a step in

length

1/3 Step

Delay is one-third step in length

1/6 Step

Delay is one-sixth step in length

Level 1: 0…100 Sets the delay amount of the first delay tap. The left and

right channels are mixed into a single delay.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 71 72

Comments to this Manuals

No comments

Dave Smith Instruments Evolver User Manual Page 23

Comments to this Manuals

Related products and manuals for Digital pianos Dave Smith Instruments Evolver